Serial ATA Power Cable
Connect your new SATA drive to the conventional four pin plug. SATA uses a different power connector than current drives, so this is a must if you dont have one.
Description:So you want to start using your brand new 150 MBytes/sec Serial ATA drive. You've installed the drive and connected the data cable but one problem: your drive uses a 15-pin SATA power connector and your power supply only has LP4 plugs. End your frustration with the RB-414, a 15-pin SATA to 4-pin LP4 Adaptor that lets you connect your SATA drive to your existing power supply.
Connects SATA Hard Drive To IDE Internal Power Connector
Length: 15 ~ 20 cm
Connector(s): a 15-pin SATA power connector
Connector(s) (Other Side): 4-pin LP4 plug
|Warranty Type||Aria Warranty Only|
|Manufacturer Phone||0906 47 00 309|
|Warranty Period (yrs)||1|
|Aria Warranty Only?||Yes|
Comments, Questions & Reviews:
Sata 111 by Russ
Will this fit sata 3 drives ?
yes this will fit all SATA power connections.
Thanks for your question.
4 pin molex by RB-414
is the molex connector on your Sata power converter RB-414 male or female - the connection I have off my corsair CX430 (purchased from you) is a 4 pin female and obviously I need a 4 pin male to connect to this. Many thanks.
These are Male Molex, this will fit on any normal PSU Molex.
Comment by Steve
I was a bit disappointed to get my shiny new SATA drive and find I needed a SATA power cable for it. It would have been great for something like a message when purchasing the drive to ask if I have the required cables? A nice way of avoiding that disappointment.
Always check you have the correct cables before buying
can this be used to power a gfx card by GJS
I want to get an HD3850 card, but my system only has sata power leads. Can I use this to connect to the graphics card via the 4-pin molex to 6-pin PCI-e connector?
No, you will need to rearrange your cables, or purchase a different PSU.
Comment by Simon B
Will this cable connect with your 80G Seagate Barracuda 7?